The quest to build and fly my own airplane has become two-faceted. To build requires careful planning, time in the shop, and craftsmanship. But in order to fly the thing, a very different sort of thinking and skills must be developed. Thus, while both consume time, one does not cast boredom onto the other. These […]
Read MoreAuthor: Mark Baldridge
Flying Lessons – Thoughts From the First 10 Hours
At the end of my most recent lesson, my log book rolled over the 10hr mark; ten hours of dual instruction in a 1999 Cessna 172R. The primary takeaway from my experience so far has been that it was not like I expected. This is not to say it was a negative experience. Simply that it […]
Read MoreBuilding the Tail Feathers
The high-level path I chose to follow for building the wooden structures was wing ribs, tail feathers, fuselage, and wing assembly. I say “wing assembly” because the bulk of the work has been done by the time the ribs are built; what remains is to put the ribs on the spars, and add all of […]
Read MoreVintage Microcomputer Clone – Sinclair ZX80
While rummaging through a box of electronic scraps and parts, I found components that were purchased nearly 10 years ago for building a Sinclair ZX80 clone. I was only 15 years old at the time, and though ambition was high, electronics experience was not, and I could never get the first piece of the circuit […]
Read MoreBuilding 32 Wing Ribs
While drawing wing ribs in AutoCad is an interesting endeavor, [EDIT 2/20/2024: I cannot recommend the CAD route. I have edited the previous post on this topic to indicate why this is a waste of time, and how it went wrong for me.] nothing sets the aviator apart from the idle dreamer like sawing spruce, […]
Read MoreHomebuilt Airplane – Pietenpol – Cost Considerations
EDIT: Since the original publication of this article, my prospective on aviation costs have changed somewhat. The thoughts in the article below do not necessarily represent my present ideas on aviation. I am writing another article which will be linked here when it is published. From any honest viewpoint, the truth remains: Aviation is expensive. If […]
Read MoreRadio Propagation Theory
The most commonly discussed trait of a particular application of radio technology is “the range.” Consumer-marketed walkie-talkies often advertise a “2 mile range” and Wi-Fi range extenders will claim to extend your network by hundreds of feet. The issue exists however, that the distance over which a radio signal is useful is entirely dependent on […]
Read MoreIntroducing Amateur Radio
There was once a time when man could not communicate without travel. The first development in this area was the telegraph which allowed messages to be sent over miles of wire. Starting in the late 19th century however, a few brilliant people such as Marconi discovered that electrical signals could travel through the air. The […]
Read MoreDrawing Wing Ribs in AutoCad
EDIT: 2/20/2024 – I cannot recommend following my example below. I printed this CAD drawing onto multiple sheets of paper, and carefully measured and taped them together to make my full-size rib layout. Unfortunately, my laser printer produced slightly trapezoidal printings – unlike the perfect rectangle that the area inside the margins should be. This […]
Read More